Anyone know about fridge-freezers?
Oct. 1st, 2009 06:11 pmMine has ceased to function - everything in the freezer is defrosted, and it's just not cold in there. Must have happened in the last 24 hours.
Now - is it worth me paying someone to look at it? Or at Fridge-freezers the kinds of things that break badly and then need to be thrown out?
Now - is it worth me paying someone to look at it? Or at Fridge-freezers the kinds of things that break badly and then need to be thrown out?
no subject
Date: 2009-10-01 05:17 pm (UTC)Depends how cheaply you can get someone to look at it I guess.
Erm, you have checked the fuse in the plug, right?
no subject
Date: 2009-10-01 05:22 pm (UTC)I'll phone someone tomorrow and see what a callout will cost.
Bah!
no subject
Date: 2009-10-01 05:23 pm (UTC)no subject
Date: 2009-10-01 05:24 pm (UTC)no subject
Date: 2009-10-01 05:25 pm (UTC)no subject
Date: 2009-10-01 05:25 pm (UTC)no subject
Date: 2009-10-01 06:50 pm (UTC)no subject
Date: 2009-10-01 06:53 pm (UTC)no subject
Date: 2009-10-01 07:19 pm (UTC)no subject
Date: 2009-10-01 08:27 pm (UTC)If it's more than 10 years old, trash it, it's done.
no subject
Date: 2009-10-01 09:11 pm (UTC)no subject
Date: 2009-10-01 09:20 pm (UTC)no subject
Date: 2009-10-01 09:51 pm (UTC)If the compressor is cooling the fridge when control is bypassed, then it is something in the control circuitry and probably worth getting an engineer out.
If the compressor has gone, then scrap it.
no subject
Date: 2009-10-01 09:52 pm (UTC)no subject
Date: 2009-10-01 10:25 pm (UTC)(Did
no subject
Date: 2009-10-02 12:00 am (UTC)I had a problem with my fridge once (not sure what caused it to begin with), and accidentally made it worse... I wanted to make things colder, so I turned the knob to make the freezer colder, but that made the vent from the freezer to the fridge close, and then the fridge got even warmer.
I had a repair person come out, and all he had to do was turn that knob, and it worked right again. :sheepish grin:
no subject
Date: 2009-10-02 01:18 am (UTC)Pull the freezer out from the wall and look for the motor that runs the compressor. It should be fairly obvious. Possibly behind a grill, or not.
Check the motor is 240V AC this should be marked on the motor, or you could test with a multi-meter , some rubber gloves and some care.
If it is 240V AC, disconnect the power wires from the controller and screw down 2 wires from a mains plug directly to the motor.
make sure everyone is clear of the machine then plug the new mains lead into the wall and switch it on.
This should run the compressor without any input from the control circuitry.
There is the possibility that a more modern fridge will have a better sealed compressor unit with clip in plugs etc.
My freezer had the motor wired to the control circuits via 2 screw type terminals. If the unit is sealed, I'd probably still have a go, but I'm not You.
no subject
Date: 2009-10-02 09:37 am (UTC)no subject
Date: 2009-10-02 10:28 am (UTC)Candidate for "Stupidest Circuit Board Design Ever".
So maybe a quick squint at the control board, if you can get to it, might be worthwhile... Make sure not to touch anyththing with anything except with the meter probes....
no subject
Date: 2009-10-02 10:32 am (UTC)